Nasos Maloudis
Digital Sculptor, Conceptual Modeling, Sketching
Portfolio
Resume
Contact
Prints

Goblin Hero Figurine

The printable figurine model for the leader of the Pinkskin Bruiser Squad bundle. Managed to keep him at ~1.4m polys while keeping this resolution, subdivision modeling in effect. This is all Zbrush work (sculpt + printability).

I am including images of the model printed on a ~16mm base (about 18mm eyeline height) so you can compare him to a standard Dungeons & Dragons halfling, a dwarf and a human sized miniature.

This is a print of the model on a 16mm base and about 20mm height on eyeline, about the size of the halfling to the right. For Pathfinder for example, you can increase the mini size while keeping the base size to meet the more "bulked" Pathfinder minis.

This is a print of the model on a 16mm base and about 20mm height on eyeline, about the size of the halfling to the right. For Pathfinder for example, you can increase the mini size while keeping the base size to meet the more "bulked" Pathfinder minis.

The print is basically on it's initial quality here, no smoothing/scraping yet. I also accidentally cut off the holstered axe's hilt and half his nose with the cutting tool, confusing them for a support... be careful with these.

The print is basically on it's initial quality here, no smoothing/scraping yet. I also accidentally cut off the holstered axe's hilt and half his nose with the cutting tool, confusing them for a support... be careful with these.

About the point I realized what I had been cutting so meticulously... if this happens to you while removing supports, use no more than a droplet of glue on the miniature, not on the cut piece, and give it 20 secs to dry a bit before merging them.

About the point I realized what I had been cutting so meticulously... if this happens to you while removing supports, use no more than a droplet of glue on the miniature, not on the cut piece, and give it 20 secs to dry a bit before merging them.

Report